WTware RDP client

Good morning.
In my RDS enviroment, we are introducing some laptops.
System does'nt recognize the touchpad (Synaptics) meanwhile it recognizes the Elan Trackpoint.
It could be that there's no driver?
It's possible to introduce it?
I attach the log file.

Paolo

It is possible to add driver if we know which one to add. There are too many chips and drivers...

1. Please try the latest wtware version and show me the same log. It should dump some more information about input devices.

2. If some other linux works with this touchpad, run:
And show me 1.txt file

PS: "extra=WTFW_i915_adlp_dmc_ver2_16.bin.zip" does not work for firmware. Write "firmware=WTFW_i915_adlp_dmc_ver2_16.bin.zip" instead of extra=

I've done the update.
I set up all the firmwares needed.
I send the new log.

I don't have a linux installation working, but if I could make a setup to find a path.
Is there a preferred version? Ubuntu?

I've done the setup of the Debian 12.
Without installing all the system, I got the log of the bootstrap.
I send it in attachments.

i2c bus

Please, run in Debian 12:
And show me /tmp/2.txt

Here the log

Ubuntu, yes.

Also, why are you sure there is Synaptics touchpad? Recognized the Elan Trackpoint does not work, no reaction at touchpad?

PS: physical display mode is "display=1920x1200". With "display=1600x900" image on screen becomes smooth. Perhaps, those two lines will make fonts large enough with clear picture:

Trackpoint works, and also the buttons left/right of the touchpad.
On another identical laptop there's a Windows 11 OS. It recognized the touchpad as a synaptics

Please try this build: http://wtware.com/testing/202407020123/ ... .29.en.zip

IT WORKS!! the pad respondes.
But the movement is very slowly. For each total-pad move, it moves on the screen about 1 cm

1. Write into config: 2. Show me log after reboot and some movements.

I set the parameter "mouse_accel_mult=16".
But now, the other mouse I attached and the trackpoint are gone crazy.
I send the current log.

Please try 6.2.30 version from https://wtware.com

Now it should understand:
For touchpad only, not for mouse.

I put on the new version and all works well.
I deleted the mouse_accel_mult parameter. It's works fine.
Thankyou very much!!! You're the best!