WTware on Raspberry Pi 3 with USB scanner

All about WTware on Raspberry. WTware works with Raspberry Pi 4, Raspberry Pi 3B+, Pi 3 and Pi 2 devices
http://www.winterminal.com
Post Reply
novotny

WTware on Raspberry Pi 3 with USB scanner

Post by novotny »

Hello, could you please help me? I´m curently using raspberry Pi3 with Wtware and scanner Symbol LS2208 connected via RS232 emulator. I want to connect it just by usb cabel, so raspberry will have to power the scanner. Would you think, that it will make problems, or is it ok to connect it that way?
akatik
SUPPORT
SUPPORT
Posts: 630
Joined: Mon Jan 17, 2005 6:30 pm
Contact:

Re: WTware on Raspberry Pi 3 with USB scanner

Post by akatik »

I expect two problems:
1. Not enough power.
2. No drivers in wtware for usb-serial bridge in scanner.
Try it with "serial=com1(usb)" in wtware config. If not working, show the log: http://wtware.com/logs.html
novotny

Re: WTware on Raspberry Pi 3 with USB scanner

Post by novotny »

I connected two terminals via USB and one works really good so far, but the other has some problems so far. The one with problems after while of working stops to scann codes.
I´m sending you both logs.

The problem one:

--- 8< --- log cutter was here --- >8 ---
novotny

Re: WTware on Raspberry Pi 3 with USB scanner

Post by novotny »

Good one:

--- 8< --- log cutter was here --- >8 ---
novotny

Re: WTware on Raspberry Pi 3 with USB scanner

Post by novotny »

Sorry, this is LOG of terminal with USB scanner, that is working fine

--- 8< --- log cutter was here --- >8 ---
akatik
SUPPORT
SUPPORT
Posts: 630
Joined: Mon Jan 17, 2005 6:30 pm
Contact:

Re: WTware on Raspberry Pi 3 with USB scanner

Post by akatik »

We've just updated our manual about logs - http://wtware.com/docs5/logs.html, please read it and make problem log again. From boot to first error. I need full problem log, with boot messages, config and other.
Post Reply