PXE boot not working

WTware network boot ways - bootable floppy, DOS, PXE-loaders, BootROM chips.
Post Reply
fedora
Posts: 1
Joined: Sun Aug 14, 2016 10:18 pm

PXE boot not working

Post by fedora » Sun Aug 14, 2016 11:03 pm

Hi,

I'm trying to use a RB Pi 2 to boot through network, but it is not working, I setup DHCP, TFTP on WTware Center, it works, gets the IP address, find the TFTP and it downloads the wtware.pxe file, but it shows the message "CACHE: Misaligned operation at range [01000000, 01003f9a] Bad LINUX ARM zImage magic!"
What's wrong?

PS: If I boot the system through the SD card it works fine! I'm able to connect to terminal server, the problem just happens through PXE boot.



Raspberry boot
boot.jpg
boot.jpg (140.13 KiB) Viewed 2989 times
Attachments
dhcp_config.PNG
dhcp_config.PNG (11.92 KiB) Viewed 2989 times

aka
SUPPORT
SUPPORT
Posts: 642
Joined: Fri Dec 03, 2004 2:05 pm
Contact:

Re: PXE boot not working

Post by aka » Mon Aug 15, 2016 10:50 pm

Do not write "5.4.40\wtware.pxe". Doubleclick on 067 line and check server autodetection.

If you reeeealy want to specify value, put "5.4.40\kernel7.img" here.

Dodavid

Re: PXE boot not working

Post by Dodavid » Sun Dec 04, 2016 4:53 pm

Hi,

i have the same problem, but I only get the message Bad Linux ARM zImage magic!

aka
SUPPORT
SUPPORT
Posts: 642
Joined: Fri Dec 03, 2004 2:05 pm
Contact:

Re: PXE boot not working

Post by aka » Sun Dec 04, 2016 8:53 pm

Did you try the same solution for the same problem?

Post Reply