WTware RDP client

I have managed to add the config file via the web interface by going to "Files in /config folder" and uploading the file.
However, my issue is that it assumes the device is already connected to your network.
I need to be able to send the config file to someone in remote location, that is not on the ...

Hi
I am trying to connect to my OpenVPN server by configuring via the WTWare console.
When I connect it asks for the 3x certificate files. But my OpenVPN server only gives 1x inline configuration file.
If I use that 1x inline configuration file and save as openvpn.cfg OpenVPN directly to disk ...

I think the extra board on the Argon is what is cutting and controlling the power. So the WTWare is not the problem. it is the Argon1 that cannot seem to switch on the Raspberry Pi from the "Red Light" state. Seems the WTWare is working as it should.
Thank you for helping. The problem is not solved ...

I use a Argon1 case with button

Argon made their own controller to switch power. We can not control them. Above I wrote about button between pin05 (GPIO03) and pin06 (ground) that should turn on halted Raspberry. Led light is turned on when Pi 4 is halted.


It does not make a difference of ...

I have upgraded the EEPROM
I use a Argon1 case with button
It switched on when you first plug in the Pi
But after shutdown from WTWare the red light stays on and it wont switch on
You have to hold in power button again for 4sec for the red light to go out, then you can switch on with switch again
If ...

Hi
When you press power off button, Pi switches "off" but the red light stays on.
Is there a way to get it to shut down completely yet from WTWare?
This will allow to power back on with button.
Now it "shuts down", but it does not switch back on again with button.
It is a big problem as I cannot ...