by geefox » Mon Nov 06, 2017 1:04 pm
Hello,
first of all thank you - the portrait mode is working with one monitor, but if I want to use the portrait mode M2_display parameter, it fails with an error with invalid argument - and is it possible to specify this: display=1920x1080, DP, portrait ?
In addition I recognize a strange behaviour:
If I attach only one monitor and configure these parameters into the config file, the monitor is working properly
- video=intel(U)
- display=1024x768, DP
but if I attach the second screen and add these parameters to the config file, the screens turns dark, and there is only an underscore blinking in the left upper corner
- M2_display=1920x1080, DP2
- M2_position=left
If I remove the video=intel(U) parameter, the screens are both working.
I've attached you two logfiles, the first one with the working monitor, and the second one with the two monitors, with the blinking underscore
best regards
- Attachments
-
- two_screens_not_working.txt
- (107.97 KiB) Downloaded 673 times
-
- one_screen_working.txt
- (123.94 KiB) Downloaded 612 times
Hello,
first of all thank you - the portrait mode is working with one monitor, but if I want to use the portrait mode M2_display parameter, it fails with an error with invalid argument - and is it possible to specify this: display=1920x1080, DP, portrait ?
In addition I recognize a strange behaviour:
If I attach only one monitor and configure these parameters into the config file, the monitor is working properly
[list][*]video=intel(U)
[*]display=1024x768, DP[/list]
but if I attach the second screen and add these parameters to the config file, the screens turns dark, and there is only an underscore blinking in the left upper corner
[list][*]M2_display=1920x1080, DP2
[*]M2_position=left[/list]
If I remove the video=intel(U) parameter, the screens are both working.
I've attached you two logfiles, the first one with the working monitor, and the second one with the two monitors, with the blinking underscore
best regards