by akatik » Sun Jul 23, 2017 8:30 am
I read p910nd source and did not find any magic, that can help USB-to-parallel-cables. Need more testing.
Please, try this build:
http://pxe.ru/files/testing/201707222329.zip
In config:
Run configurator at any Windows machine, find Pi in the list, open "Logs" tab. Press big button to start logging. DO NOT close Configurator, DO NOT reboot Pi (or restart logging if reboot).
And wait until printer stops.
Then save the log and send to
support@wtware.com
Try to change "500" value. It's delay in milliseconds. Wtware will wait every time after it sends chunk of data to printer.
Did you use bi-direction mode in p910nd?
I read p910nd source and did not find any magic, that can help USB-to-parallel-cables. Need more testing.
Please, try this build:
http://pxe.ru/files/testing/201707222329.zip
In config:
[code]printer = usb(delay 500), debug[/code]
Run configurator at any Windows machine, find Pi in the list, open "Logs" tab. Press big button to start logging. DO NOT close Configurator, DO NOT reboot Pi (or restart logging if reboot).
And wait until printer stops.
Then save the log and send to support@wtware.com
Try to change "500" value. It's delay in milliseconds. Wtware will wait every time after it sends chunk of data to printer.
Did you use bi-direction mode in p910nd?