PXE boot not working

Post a reply

Smilies
:D :) :( :o :shock: :? 8) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :wink: :!: :?: :idea: :arrow: :| :mrgreen:

BBCode is OFF
Smilies are ON

Topic review
   

Expand view Topic review: PXE boot not working

Re: PXE boot not working

by aka » Sun Dec 04, 2016 8:53 pm

Did you try the same solution for the same problem?

Re: PXE boot not working

by Dodavid » Sun Dec 04, 2016 4:53 pm

Hi,

i have the same problem, but I only get the message Bad Linux ARM zImage magic!

Re: PXE boot not working

by aka » Mon Aug 15, 2016 10:50 pm

Do not write "5.4.40\wtware.pxe". Doubleclick on 067 line and check server autodetection.

If you reeeealy want to specify value, put "5.4.40\kernel7.img" here.

PXE boot not working

by fedora » Sun Aug 14, 2016 11:03 pm

Hi,

I'm trying to use a RB Pi 2 to boot through network, but it is not working, I setup DHCP, TFTP on WTware Center, it works, gets the IP address, find the TFTP and it downloads the wtware.pxe file, but it shows the message "CACHE: Misaligned operation at range [01000000, 01003f9a] Bad LINUX ARM zImage magic!"
What's wrong?

PS: If I boot the system through the SD card it works fine! I'm able to connect to terminal server, the problem just happens through PXE boot.



Raspberry boot
boot.jpg
boot.jpg (140.13 KiB) Viewed 12658 times
Attachments
dhcp_config.PNG
dhcp_config.PNG (11.92 KiB) Viewed 12658 times

Top