Hello, I just installed WTware on my Raspberry Pi 2, it works fine however the problem is there is no sound and no USB redirection.
I tried to plug a USB flash drive into Raspberry PI 2 port and the Remote Windows machine cannot detect the USB.
What configuration is needed to make USB work and also make sound work.
No sound and no USB redirection with Raspberry Pi 2
Re: No sound and no USB redirection with Raspberry Pi 2
In terminal configuration file specifyWhat configuration is needed to make USB work
Code: Select all
disk=usb
Onboard sound at RPi should be enabled in config.txt at SD card now. To edit config.txt, you can use a browser, http://[terminal-ip]/and also make sound work.
# Enable onboard audio (HDMI or jack).
and the sound option should be ondtparam=audio=on
Code: Select all
sound=on
Re: No sound and no USB redirection with Raspberry Pi 2
Thanks aka, it works now.
Re: No sound and no USB redirection with Raspberry Pi 2
I'm having almost the exact same problem, except that I have dtparam=audio=on uncommented in my config.txt. I can get audio to work, but only if I first run the Sound Test from the terminal information page. If I simply log in from the RPi 3, I can move the sound control, but no sound comes through until I run the test.
Re: No sound and no USB redirection with Raspberry Pi 2
1. Reboot.
2. Log into Windows. Play sound from Windows. Can you hear it?
3. Run Test Sound. Can you hear it?
4. Play sound from Windows again. Can you hear it?
5. Take terminal log http://wtware.com/logs.html and send it to support@wtware.com
2. Log into Windows. Play sound from Windows. Can you hear it?
3. Run Test Sound. Can you hear it?
4. Play sound from Windows again. Can you hear it?
5. Take terminal log http://wtware.com/logs.html and send it to support@wtware.com